欢迎您光临济南苏鑫电缆桥架有限公司官方网站!
联系济南苏鑫电缆桥架有限公司 / Contact us

济南苏鑫电缆桥架有限公司

客户统一咨询热线

0531-85767688

售后热线:137-0540-5406

联系基地:山东省 德州市协同发展产业园D06幢

当前位置:首页 > 新闻中心 > 公司新闻 >

电缆桥架在电气竖井内使用时需要符合哪些要求?

文章来源:http://www.sddlqj.cn/   作者:电缆桥架厂家   发布时间:2021-10-06   浏览次数:

返回:公司新闻
竖井内的配电箱应有出厂合格证、生产许可证、“CCC*认证标志和认证证书复印件及试验记录。
The distribution box in the shaft shall be provided with factory certificate, production license, "CCC * certification mark, copies of certification certificate and test records.
电气竖井内所用的电缆桥架规格型号要符合设计要求。采用镀锌制品、镀锌钢板的厚度在桥架宽度小于400mm时,厚度不小于15mm;在400~800mm之间时,厚度不小于2mm;大于800mm时,厚度不小于2.5mm。
The specifications and models of cable trays used in the electrical shaft shall meet the design requirements. The thickness of galvanized products and galvanized steel plates shall not be less than 15mm when the bridge width is less than 400mm; not less than 2mm when the bridge width is between 400 ~ 800mm; and not less than 2.5mm when the cable tray width is greater than 800mm.
防火堵料(防火枕)、防火涂料应选用经国家鉴定的定型产品。
Fireproof plugging material (fireproof pillow) and fireproof coating shall be finalized products identified by the state.
电气竖井中使用的辅助材料钻头、电焊条、氧气、乙炔气、调合漆、焊锡、焊剂、橡胶绝缘带、塑料绝缘带、黑胶布等。
Auxiliary materials used in the electrical shaft include drill bit, welding electrode, oxygen, acetylene gas, blending paint, solder, flux, rubber insulating tape, plastic insulating tape, black tape, etc.
金属膨胀螺栓根据允许拉力和剪力及设备的安装孔径确定。
The metal expansion bolt shall be determined according to the allowable tension and shear force and the installation hole diameter of the equipment.
接线端子根据导线截面及导线根数选,用相应规格的接线端子。
The wiring terminal shall be selected according to the wire section and the number of wires, and the wiring terminal of corresponding specification shall be used.
电缆桥架应平直无明显扭曲,支架应焊接牢固无显著变形;下料误差应在5mm范围内,切口应无卷边毛刺。
The cable tray shall be straight without obvious distortion, the support shall be welded firmly without significant deformation; the blanking error shall be within 5mm, and the notch shall be free of crimping burr.
电线、电缆及附件应选用符合国家现行技术标准的产品并应有出厂合格证、“CCC认证标志和认证证书复印件。电线、电缆桥架还应有生产许可证,符合电缆桥架的规格选择。
Wires, cables and accessories shall be products that meet the current national technical standards, and shall be provided with factory certificate, "CCC certification mark" and copies of certification certificate. Wires and cable trays shall also be provided with production license to meet the specification selection of cable tray.
工程案例 / Case Show
  • 济南火车站 济南火车站
  • 曲阜孔子文化会展中心 曲阜孔子文化会展中心
  • 山东工艺美院 山东工艺美院
  • 山东桥架厂家带你了解槽式电缆桥架与桥式电缆桥架区别 山东桥架厂家带你了解槽式电缆桥架与桥式电缆桥架区别
推荐资讯 / Recommended news
  • 电缆桥架的结构分析电缆桥架的结构分析

    电缆桥架应进行整体作用效应分析;同时应对电缆桥架中受力状况特殊部位进行深化分析。Overall action effect analysis shall be condu

    TIME:2021-11-19